products

※Structural features：
★Heating plate surface by grinding treatment, hot plate width 600mm, a total of 12 heating plate and cooling 4 m。
★Heating plate with a container board production, in line with national standards for a class pressure vessel, with pressure vessel certificate and inspection certificate。
★Hot plate with intensive gravitational roll structure. Roll adopt pneumatic lifting.
★Heating plate heat transfer pipe temperature control sub-four-segment, with a temperature display.
★on cotton use two-cylinder S type cotton belt with the tensioning device.
★lower belt adopt pneumatic tensioning.
★Drive roller coated with attached wear-resistant rubber ，showed a herringbone structure，With a high, ensure smooth cardboard output。
★Main drive motor for frequency conversion motor，low-speed torque，wide speed range ,reliable, and easy maintenance.
★hot plate internal for partition isolation structure,s-shaped flow of steam，Steam, water separation function significantly improves the utilization of steam。
※Technical parameters：
1、temperature requirement：160—200℃   steam pressure：0.8-1.3Mpa
2、air source pressure：0.6—0.9Mpa
3、Cooling stereotypes length：4m       Heating plate quantity：12 pieces
4、hydraulic system pressure：6—8Mpa
※Roller diameter parameters：
1、upper drive rubber roller diameter：￠475mm　lower drive rubber roller diameter：￠350mm　Wear rubber Outsourcing
2、Former follower with roller diameter：￠176mm　back setting belt driven roller diameter：￠176mm
3、Platen roller：￠85mm　Setting roller diameter：￠86mm
4、upper belt tension roller diameter：￠155mm　upper roll diameter with detuning：￠124mm
5、Lower belt tension roller diameter：￠130mm　Entrusted with the roll diameter lower belt：￠130mm
Note: All the roller surface after grinding are hard chrome plated
※Powered motor parameters：
1、Main drive motor power：22KW　380V　50Hz　Continuous (S1) working standard
※Mainly purchased parts, raw materials and origin：